EZCleanFilter

Step 1:

Remove rubber bands.

Step 2:

Unwrap mesh from posts.

Step 3:

Pull mesh to unwrap from center tube.

Step 4:

Wash mesh with water to clean filter.

Step 1:

To assemble the filter, the mesh is placed between the cartridge end plates with the mesh laid flat in between both endplates. One end of the mesh is laid against the center tube with the mesh running end outside the posts.

Step 2:

The center tube is rotated inside the cage at least three complete turns such that the center tube has at least 3 full inner wraps of the mesh around it.

Step 3:

Then the mesh running end is wrapped at least one full outer wrap around the posts. There is a connecting section of the mesh between the inner and outer wraps.

Step 4:

When the wraps are completed, the mesh second end is a free end outside of the outerwrap. The mesh is held in place on the cartridge by 3 chemical resistant rubber bands that surround and hold the mesh outer wrap against the posts. Put 2 rubber bands tight to the outside ends and one in the middle.

When the filter goes into the pump there is a raised section that goes into the filter on top and bottom of pump. The gaskets go around these sections on top and bottom , Note this is the same for all the different pumps.